D-Link DES-3226L, Cli Command Reference

Page: 48 / 128

48 D-Link DES-3226L Command Line Reference
no snmp trap link-status all
This command disables link status traps for all interfaces. This command is valid only when the Link
Up/Down Flag is enabled. See “snmp-server enable traps linkmode” on page 45.
Format
no snmp trap link-status all
Mode
Global Config
show snmpcommunity
This command displays SNMP community information. Six communities are supported. You can add,
change, or delete communities. The switch does not have to be reset for changes to take effect.
The SNMP agent of the switch complies with SNMP Versions 1, 2 or 3. For more information about the
SNMP specification, see the SNMP RFCs. The SNMP agent sends traps through TCP/IP to an external
SNMP manager based on the SNMP configuration (the trap receiver and other SNMP community
parameters).
Format
show snmpcommunity
Mode
Privileged EXEC
SNMP Community Name
The community string to which this entry grants access. The
string is case-sensitive and can have up to 16 characters. Each row of this
table must contain a unique community name.
Client IP Address
An IP address (or portion thereof) from which this device will accept
SNMP packets with the associated community. The requesting entity's IP
address is ANDed with the Subnet Mask before being compared to the IP
Address. Note: If the Subnet Mask is set to 0.0.0.0, an IP Address of 0.0.0.0
matches all IP addresses. The default value is 0.0.0.0
Client IP Mask
A mask to be ANDed with the requesting entity's IP address before com-
parison with IP Address. If the result matches with IP Address then the
address is an authenticated IP address. For example, if the IP Address =
9.47.128.0 and the corresponding Subnet Mask = 255.255.255.0 a range of
incoming IP addresses would match, i.e. the incoming IP Address could equal
9.47.128.0 - 9.47.128.255. The default value is 0.0.0.0
Access Mode
The access level for this community string.
Status
The status of this community access entry.
show trapflags
This command displays trap conditions. Configure which traps the switch should generate by enabling
or disabling the trap condition. If a trap condition is enabled and the condition is detected, the SNMP
agent on the switch sends the trap to all enabled trap receivers. You do not have to reset the switch to
implement the changes. Cold and warm start traps are always generated and cannot be disabled.
Format
show trapflags
Mode
Privileged EXEC
Authentication Flag
Can be enabled or disabled. The factory default is enabled. Indicates
whether authentication failure traps will be sent.