Setup and Management Commands
31
telnetcon timeout
This command sets the telnet connection session timeout value, in minutes. A session is active as long
as the session has not been idle for the value set. The time is a decimal value from 1 to 160.
Note:
Changing the timeout value for active sessions does not become effective until the
session is reaccessed. Also, any keystroke activates the new timeout duration.
Default
5
Format
telnetcon timeout <1-160>
Mode
Privileged EXEC
no telnetcon timeout
This command sets the telnet connection session timeout value to the default.
Note:
Changing the timeout value for active sessions does not become effective until the
session is reaccessed. Also, any keystroke activates the new timeout duration.
Format
no telnetcon timeout
Mode
Privileged EXEC
bridge aging-time
This command configures the forwarding database address aging timeout in seconds. In an IVL system,
the [fdbid | all] parameter is required. The <seconds> parameter must be within the range of 10 to
1,000,000 seconds. Fdbid (Forwarding database ID) indicates which forwarding database's aging
timeout is being configured. The All option is used to configure all forwarding database's agetime.
Default
300
Format
bridge aging-time <10-1,000,000> [fdbid | all]
Mode
Global Config
no bridge aging-time
This command sets the forwarding database address aging timeout to 300 seconds. In an IVL system,
the [fdbid | all] parameter is required. Fdbid (Forwarding database ID) indicates which forwarding
database's aging timeout is being configured. All is used to configure all forwarding database's agetime.
Format
no bridge aging-time [fdbid | all]
Mode
Global Config
network javamode
This command specifies whether or not the switch should allow access to the Java applet in the header
frame of the Web interface. When access is enabled, the Java applet can be viewed from the Web
interface. When access is disabled, the user cannot view the Java applet.
Default
enabled
Format
network javamode
Mode
Privileged EXEC
Summary of Contents for DES-3226L
