D-Link DES-3226L, Cli Command Reference

Page: 35 / 128

Setup and Management Commands 35
being logged off. May be specified as a number from 1 to 160. The factory
default is 5.
Maximum Number of Remote Connection Sessions
This object indicates the number
of simultaneous remote connection sessions allowed. The factory default is 5.
Allow New Telnet Sessions
Indicates that new telnet sessions will not be allowed when set
to no. The factory default value is yes.
show serial
This command displays serial communication settings for the switch.
Format
show serial
Modes
Privileged EXEC
User EXEC
Serial Port Login Timeout (minutes)
Specifies the time, in minutes, of inactivity on a
Serial port connection, after which the Switch will close the connection. Any
numeric value between 0 and 160 is allowed, the factory default is 5. A value
of 0 disables the timeout.
Baud Rate (bps)
The default baud rate at which the serial port will try to connect. The
available values are 1200, 2400, 4800, 9600, 19200, 38400,57600, and
115200 baud. The factory Default is 9600 baud.
Character Size (bits)
The number of bits in a character. The number of bits is always 8.
Flow Control
Whether Hardware Flow-Control is enabled or disabled. Hardware Flow
Control is always disabled.
Stop Bits
The number of Stop bits per character. The number of Stop bits is always 1.
Parity Type
The Parity Method used on the Serial Port. The Parity Method is always
None.
System Configuration Commands
This section describes the commands you use to view and configure port settings.
addport
This command adds one port to the port-channel (LAG). The first interface is a logical slot and port
number of a configured port-channel.
Note: Before adding a port to a port-channel, set the physical mode of the port. For more
information, see “speed” on page 39.
Format
addport <logical slot/port >
Mode.
Interface Config