D-Link DES-3226L, Cli Command Reference

Page: 37 / 128

Setup and Management Commands 37
monitor session
This command configures a probe port and a monitored port for monitor session (port monitoring). The
first <slot/port> is the source monitored port and the second <slot/port> is the destination probe port.
The monitor session (port monitoring) mode becomes enabled only when both the probe and monitored
ports are configured. If enabled, the probe port monitors all the traffic received and transmitted on the
physical monitored port.
Format
monitor session <session-id> source interface < slot/port > desti-
nation interface < slot/port >
Mode
Global Config
no monitor session
This command removes the monitor session (port monitoring) designation from the source probe port,
the destination monitored port and all VLANs. Once the port is removed from the VLAN, the user must
manually add the port to any desired VLANs.
Note: This command sets the monitor session (port monitoring) mode to disable.
Format
no monitor session <session-id>
Mode
Global Config
no monitor
This command removes all the source ports and a destination port and restores the default value for
mirroring session mode for all the configured sessions.
Note: This is a stand-alone “no” command. This command does not have a “normal” form.
Default
enabled
Format
no monitor
Mode
Global config
no monitor session 1
This command removes all the source ports and a destination port of the mirroring session and restores
the default value for mirroring session mode. The <session-id> parameter is an integer value used to
identify the session. In the current version of the software, the <session-id> parameter is always 1.
Note: This is a stand-alone “no” command and does not have a “normal” form. This com-
mand can be issued without regard for the session status (enabled or disabled).
Default
enabled
Format
no monitor session <session-id>
Mode
Global config