D-Link DES-3226L, Cli Command Reference

Page: 68 / 128

68 D-Link DES-3226L Command Line Reference
no spanning-tree configuration revision
This command sets the Configuration Identifier Revision Level the default value of 0.
Format
no spanning-tree configuration revision
Mode
Global Config
spanning-tree edgeport
This command specifies that this port is an Edge Port within the common and internal spanning tree.
This allows this port to transition to Forwarding State without delay.
Format
spanning-tree edgeport
Mode
Interface Config
no spanning-tree edgeport
This command specifies that this port is not an Edge Port within the common and internal spanning tree.
Format
no spanning-tree edgeport
Mode
Interface Config
spanning-tree forceversion
This command sets the Force Protocol Version parameter to a new value. The Force Protocol Version
can be one of the following:
z
802.1d - ST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1d functionality supported)
z
802.1w - RST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1w functionality supported)
z
802.1s - MST BPDUs are transmitted (IEEE 802.1s functionality supported)
Default
802.1s
Format
spanning-tree forceversion <802.1d | 802.1w | 802.1s>
Mode
Global Config
no spanning-tree forceversion
This command sets the Force Protocol Version parameter to the default value, i.e. 802.1s.
Format
no spanning-tree forceversion
Mode
Global Config
spanning-tree forward-time
This command sets the Bridge Forward Delay parameter to a new value for the common and internal
spanning tree. The forward-time value is in seconds within a range of 4 to 30, with the value being
greater than or equal to “(Bridge Max Age / 2) + 1”.
Default
15
Format
spanning-tree forward-time <4-30>
Mode
Global Config