D-Link DES-3226L, Cli Command Reference

Page: 34 / 128

34 D-Link DES-3226L Command Line Reference
show network
This command displays configuration settings associated with the switch's network interface. The
network interface is the logical interface used for in-band connectivity with the switch via any of the
switch's front panel ports. The configuration parameters associated with the switch's network interface
do not affect the configuration of the front panel ports through which traffic is switched or routed.
Format
show network
Modes
Privileged EXEC
User EXEC
IP Address
The IP address of the interface. The factory default value is 0.0.0.0
Subnet Mask
The IP subnet mask for this interface. The factory default value is 0.0.0.0
Default Gateway
The default gateway for this IP interface. The factory default value is
0.0.0.0
Burned In MAC Address
The burned in MAC address used for in-band connectivity.
Locally Administered MAC Address
If desired, a locally administered MAC address
can be configured for in-band connectivity. To take effect, 'MAC Address
Type' must be set to 'Locally Administered'. Enter the address as twelve hexa-
decimal digits (6 bytes) with a colon between each byte. Bit 1 of byte 0 must
be set to a 1 and bit 0 to a 0, i.e. byte 0 should have the following mask 'xxxx
xx10'. The MAC address used by this bridge when it must be referred to in a
unique fashion. It is recommended that this be the numerically smallest MAC
address of all ports that belong to this bridge. However it is only required to
be unique. When concatenated with dot1dStpPriority a unique BridgeIdenti-
fier is formed which is used in the Spanning Tree Protocol.
MAC Address Type
Specifies which MAC address should be used for in-band connectiv-
ity. The choices are the burned in or the Locally Administered address. The
factory default is to use the burned in MAC address.
Network Configuration Protocol Current
Indicates which network protocol is being
used. The options are bootp, dhcp, and none.
Java Mode
Specifies if the switch should allow access to the Java applet in the header
frame. Enabled means the applet can be viewed. The factory default is dis-
abled.
Web Mode
Specifies if the switch should allow access to the Web Interface.
show telnetcon
This command displays telnet settings.
Format
show telnetcon
Modes
Privileged EXEC
User EXEC
Remote Connection Login Timeout (minutes)
This object indicates the number of
minutes a remote connection session is allowed to remain inactive before