D-Link DES-3226L, Cli Command Reference

Page: 96 / 128

96 D-Link DES-3226L Command Line Reference
Note: To re-configure a RADIUS accounting server to use the default UDP <port>, set the
<port> parameter to 1813.
Format
radius server host {auth | acct} <ipaddr> [<port>]
Mode
Global Config
no radius server host
This command is used to remove the configured RADIUS authentication server or the RADIUS
accounting server. If the 'auth' token is used, the previously configured RADIUS authentication server is
removed from the configuration. Similarly, if the 'acct' token is used, the previously configured
RADIUS accounting server is removed from the configuration. The <ipaddr> parameter must match the
IP address of the previously configured RADIUS authentication / accounting server.
Format
no radius server host {auth | acct} <ipaddress>
Mode
Global Config
radius server key
This command is used to configure the shared secret between the RADIUS client and the RADIUS
accounting / authentication server. Depending on whether the 'auth' or 'acct' token is used, the shared
secret is configured for the RADIUS authentication or RADIUS accounting server. The IP address
provided must match a previously configured server. When this command is executed, the secret is
prompted.
Note: The secret must be an alphanumeric value not exceeding 16 characters.
Format
radius server key {auth | acct} <ipaddr>
Mode
Global Config
radius server msgauth
This command enables the message authenticator attribute for a specified server.
Default
radius server msgauth <ipaddr>
Mode
Global Config
no radius server msgauth
This command disables the message authenticator attribute for a specified server.
Default
no radius server msgauth <ipaddr>
Mode
Global Config
radius server primary
This command is used to configure the primary RADIUS authentication server for this RADIUS client.
The primary server is the one that is used by default for handling RADIUS requests. The remaining
configured servers are only used if the primary server cannot be reached. A maximum of three servers
can be configured on each client. Only one of these servers can be configured as the primary. If a
primary server is already configured prior to this command being executed, the server specified by the