2. Open the front door of the cabinet.
3. Disconnect the Ethernet and serial cables from the front of the cabinet controller and label all cables.
4. Simultaneously pull out on both extractor handles until they stop.
5. Slide the cabinet controller straight out of the cabinet and set it on an ESD-safe surface.
Figure 45. Cabinet Controller
Ethernet cables
Serial cables
Extractor
handles
2.10.2 Install a Cabinet Controller
Prerequisites
Tools Required:
Small slotted screwdriver
Time Required:
5 minutes
About this task
Procedure
1. Align the guide rail on the cabinet controller with the guide slot in the front of the chassis.
Figure 46. Cabinet Controller
Ethernet cables
Serial cables
Extractor
handles
2. Slide the cabinet controller into the chassis until it stops.
Push the center of the face plate to avoid pinching fingers under the extractor handles.
3. Engage the tabs on the extractor handles with the extractor flanges on the sides of the chassis.
System Cabinet Procedures
53