Corghi ERCO 500, Operator'S Manual, Page: 70 / 184

7 0
8 CHAPTER 8 - OPERATION AND USE
8.1 CONTROLS
Controls for operating the lift are:
MAIN SWITCH
(1)
The function control can be set in five positions:

0 position: lift electric circuit is not powered; the switch can be padlocked to prevent the use of the lift.

1 position: lift electric circuit is powered
LIFTING BUTTON
(2)

When pressed, motor and hydraulic circuit solenoid valve are operated and the lift will be raised
LOWERING BUTTON
(3)

When pressed, the release hydraulic circuit solenoid valve, the lift will lower with warning signal.
PLUG HOLE (5)
PILOT LAMP ( 4 )

it shows the electric circuit is powered
Figura 17a – CONTROLS
Be sure the safety area is free from people and objects during the final
travel
Lift operation can be summarized into four steps:
8.2 VEHICLE POSITIONING

Place the vehicle at the centre of the platform and adjust the telescopic extensions.

Place pads under the positions indicated by the motor vehicle’s manufacturer for lifting.
8.3 LIFTING

Set the main switch (1) to 1 position and press UP button to lift the vehicle to the required
level.
1
1
1 1
1
1
2
3
5
4
5