Ref.no.: 003274/Revision 2.4 @2019 Control Data Systems Page 168
|
201
7.3.7.3
VR910 Settings
The VR950 Settings page enables you to change the network settings for the VR950.
In the following screen capture (
Figure 7.3.9
) is displayed the VR950 Settings window:
Figure 7.3.10 VR950 Settings window (HART)
Setting the VR950
To set VR950 you must perform the following actions:
1.
edit the input fields for IP,
Gateway
and
Mask
;
2.
you can also change the MAC of the VR:
a.
Check the “Update MAC” option to enable the MAC edit field,
b.
type the new MAC;
c.
optionally, uncheck the
Update MAC
option to protect the field from being accidentally
edited;
3.
use the
Delete
and
Add
buttons to remove or add name servers or NTP servers.
After you finish editing the settings, click
Save
and reset the board for the settings to take effect.
Note:
If you change the IP address, the board will be accessible with the new IP after reset and will no
longer be reachable at the previous IP.
7.4
Statistics
The System Status page displays statistical information regarding processor and memory usage, and load
average on the VR910.
In the following screen capture (
Figure 7.4.1
) are shown the section of the Statistic page:
