Ref.no.: 003274/Revision 2.4 @2019 Control Data Systems Page 114
|
201
Figure 6.3.11 VR950 Settings window (ISA 100)
Setting the VR950
To set VR950 you must perform the following actions:
1.
edit the input fields for
IP
,
Gateway
and
Mask
;
2.
you can also change the MAC of the VR, as follows:
•
check the
Update MAC
option to enable the MAC edit field;
•
type the new MAC;
•
optionally, uncheck the
Update MAC
option to protect the field from being accidentally
edited;
3.
use the
Delete
and
Add
buttons to remove or add name servers or NTP servers.
After you finish editing the settings, click
Save
and reset the board for the settings to take effect.
Note:
If you change the IP address, the board will be accessible with the new IP after reset and will no
longer be reachable at the previous IP.
6.3.11
Bulk Transfers
The Bulk Transfers page enables you to create and configure bulk transfers. Bulk data transfers are used
to transfer large items between wireless devices (sensor boards) and GW clients. This can be done via
two methods:
•
a transfer method described by ISA running on top of UDO;
•
a CDS enhanced bulk data transfer protocol.
For details about the two methods, see the document entitled:
96-00006-01 ISA100.11a GSAP Interface
Specification
.
