Ref.no.: 003274/Revision 2.4 @2019 Control Data Systems Page 80
|
201
Command sent error
). The tracking number of the command is also indicated, together with a link to the
Commands Log (please see the
Section 6.2.7.
, where you can view the results of the command.
In the following sections are described the available types of commands.
6.2.4.7.1
Read Value
The command
Read Value
is available only for
field devices and enables you to read a value of a
particular channel of the selected device.
In the following screen capture (
Figure 6.2.14
) is displayed the Read Value window:
Figure 6.2.14 Read Value command window (ISA 100)
To generate the command, select the process value for which to request a reading and click
Execute
. The
returned value will be displayed in the Readings page, in engineering units under the
Value
column as
well as in the Command Log, under the
Response
column.
Note
:
When the device is unregistered, the Run Commands page is unavailable.
6.2.4.7.2
Reset Device
The command
Reset Device
resets the firmware on the specific device.
Three types of resets can be performed on a device, as follows:
•
Warm Restart – performs a software reset; therefore, the device will unregister and re-
register;
•
Restart as provisioned – resets the device while keeping provisioning information;
•
Reset to factory defaults – deletes the provisioning information and resets the device to its
manufacturing settings; the device must be re-provisioned in order to be able to join the
network.
In the following screen capture (
Figure 6.2.15
) is displayed the Reset Device window with the
Restart
Type
s available:
