Ref.no.: 003274/Revision 2.4 @2019 Control Data Systems Page 159
|
201
1.
select the desired entry in the list and click
Delete
;
2.
you will be asked for confirmation; click
Yes
to delete the device(s) or
No
to abort the action.
After you perform any of the above operations, click
Activate
to load the changes into the NM. The
changes will be visible in the network topology and where applicable in the device list.
Loading a List of Devices
You can add multiple devices at the same time by importing them from a file. The file will contain a list of
devices with the <EUI64>, <Key>, and <NetworkID> when appropriate, comma separated values.
Loading a List of Devices
To load a list, you must perform the following actions:
1.
click on
Browse
to locate the text file that you wish to load, and click
Upload
;
2.
click
Activate
, to load the new device list into the NM; the current
whart_provisioning.ini
file will
be overwritten, and all previous settings will be lost.
Exporting the Settings
This page also enables you to export the configuration settings, by clicking
Save
in the
Manage device list
section.
7.3.5
Monitoring Host
This section enables you to configure burst messages (data publishing from devices to GW and
visualization in MCS web interface). The configuration settings are stored in the
Monitor_Host_Publishers.conf
file.
By default, the system will automatically discover the settings for burst messages for devices joined to
the network, provided that such information was not manually entered in
Monitor_Host_Publishers.conf
file or a discovery process was not run previously, filling the appropriate settings in the file.
Click
Help
in the upper right corner of the window to view information and examples of the accepted
data formats in all the sections.
In the following screen capture (
Figure 7.3.6
) is displayed the Device Management window:
