Ref.no.: 003274/Revision 2.4 @2019 Control Data Systems Page 145
|
201
Figure 7.2.12 Run Commands window (HART)
To go to a specific command, select it from the
Commands
drop-down list. After you generate the
command, a message at the bottom of the screen will indicate its status (
Command sent successfully
,
Command sent error
). The tracking number of the command is also indicated, together with a link to the
Commands Log (please see the
Section 7.2.7.
, where you can view the results of the command.
Note
: Currently only the
Wireless HART General Command
is supported. Other commands may be added
in the future.
7.2.4.6.1
WH General Command
This set encompasses all the general commands that can be issued on the devices (e.g. 800 - read service
list, 782 - read session list, etc.). To generate the command, follow the steps described below:
1.
select the
WH General Commands
set from the
Command
drop-down list;
2.
optionally, select the
BypassIOCache
value:
•
Yes
– if you wish to retrieve the response to the command directly from the device;
•
No
– if you wish to obtain the response from the GW cache;
•
If you do not select a value, the default value
No
will be considered;
3.
type the command number in the
CommandNo
field;
4.
for commands that have parameters, type the content of the request in the
Command (hex)
field;
5.
press
Execute
; a message at the bottom of the screen will indicate the command status
(
Command sent successfully
,
Command sent error
); the tracking number of the command is also
indicated, together with a link to the Commands Log, where you can view the response.
In the following screen capture (
Figure 7.2.13
) is displayed the WH General Command window:
