Ref.no.: 003274/Revision 2.4 @2019 Control Data Systems Page 157
|
201
If the
Join Key
differs from device to device, you must enter the correct EUI-64 address and join key for
each device, for the devices to be able to join. Afterwards, click
Save
to save the data in the
whart_provisioning.ini
file.
In the following screen capture (
Figure 7.3.5
) is shown the Configuration settings window:
Figure 7.3.5 Configuration settings window (HART)
At the end, click
Activate
, to activate the configuration settings.
If you have more than one Access Point set in the network, you can set one of them redundant for the
other. Both will advertise the same
Network ID
.
7.3.4.1
Configuring Access Points
To add an AP in the network, type its
EUI64
, security key, and
Network ID
in an empty edit box and click
Save.
The new AP will be added to the Access Points list.
Editing an AP
To edit an AP, you must perform the following actions:
1.
click on the entry that you want to edit in the Access Points list;
2.
edit the security key and/or network ID and click
Save
to save the changes in the
whart_provisioning.ini
file.
Considering Note 1 above, if you change the EUI64 address of an existing AP, the NM will recognize it as a
new entity and will add the new AP to the current list.
Considering Notes 2 above, if you edit an Access Point, it will be removed from an existing network and
the devices in that network will be unable to join the network, unless you edit the same parameters for all
the field devices in that network.
Deleting an AP
To delete an Access Point you must perform the following actions:
1.
select the desired Access Point in the list and click
Delete
;
2.
you will be asked for confirmation; click
Yes
to delete the AP or
No
to abort the action.
