Contec FX-DS110-APE, User Manual

Page: 44 / 132

Installation Method
FX-DS110-APE
33
Wall Installation
Wall-mount fittings are provided for installing the unit on a wall.
Attach the unit to a stable vertical wall and ensure that adequate
space is provided for ventilation (5cm). As far as possible, locate
the unit in a high place with an unobstructed view as this gives
better radio transmission and reception performance and increases
the operating range. Also, locating the unit (antenna) too close to
concrete or metal walls (including steel frames) causes a reduction
in communication quality. If mounting the unit on a metal or
concrete wall, ensure a gap of at least 30cm from the wall.
115mm
94mm
103.4mm
Wall mount holes
The provided wall-
mount fittings
Screws
Figure 4.3. Wall Installation
To mount the unit on a wall, obtain the required number of screws
(to fit
φ
3.5).
(1) Use the screws to attach the provided wall-mount fittings to
the wall. The dimensions are shown in the figure above. (4
locations)
(2) Attach the AP case such that the four wall-mount fittings on
the wall insert into the wall-mount holes on the case.
(3) Slide the AP unit down to hold it in place.