Contec FX-DS110-APE, User Manual, Page: 86 / 132

Software Setup
FX-DS110-APE
75
Decline ANY ID
This specifies whether to decline logins from stations with ESSID
set to “ANY”.
Logins are declined if “Enable” is set. The factory default setting
is “Disable”.
Encryption (WEP)
This specifies whether to enable the WEP function. Specify the
number of the WEP key to use for data transmission in the default
transmit key setting. Enter WEP keys in hexadecimal format (0 to
9 and a to f or A to F). Enter 10 digits for a 40-bit key and enter
26 digits for a 128-bit key. The keys are not used if this function
is disabled. The factory default setting is “Disable”.
SNMP Relation
Community name
This is the SNMP authentication character string. That is, it acts
as a password for using SNMP to access the AP. The program
uses this community name to access the AP’s MIB. The
community name is case sensitive and can be a maximum of 16
bytes in length. The factory default setting is “public”.
Community access permissions
Sets the access permissions for the community. Specify whether
reading only (Read) or reading and writing (Read&Write) are
permitted. The factory default setting is “Read&Write”.
Device name
The device name of the AP for SNMP. The name can be up to 32
bytes in length. The factory default setting is “FLEXLAN”.
Device physical location
Specifies the physical location of the AP. An example is
“Administration Dept., 3rd Floor”. A character string up to 32
bytes can be entered.