78 - Network Redundancy | STP Configuration Page
RocketLinx WR7802-XT Series User Guide
: 2000638 Rev. A
Configuration Using the Web User Interface
Once you have completed your configuration, click on
Apply
to apply your settings.
Note:
You must observe the following rule to configure Hello Time, Forwarding Delay, and Max Age
parameters.
2 × (Forward Delay Time – 1 sec) ? Max Age Time ? 2 × (Hello Time value + 1 sec)
Note:
You must
Save
) settings, if you want to maintain these settings if the WR7802-XT is rebooted.
Hello Time (1-10)
Enter a value from 1 to 10 seconds. This is a periodic timer that drives
the router to send out BPDU (Bridge Protocol Data Unit) packet to check
current STP status.
The root bridge of the spanning tree topology periodically sends out a
hello message to other devices on the network to check if the topology is
healthy. The hello time is the amount of time the root has waited during
sending hello messages.
Forward Delay
Time (4-30)
Enter a value between 4 and 30 seconds. This value is the time that a
port waits before changing from Spanning Tree Protocol learning and
listening states to forwarding state. This is the amount of time the device
waits before checking to see if it should be changed to a different state.
STP Configuration (Continued)
Beta
Version
