RocketLinx WR7802-XT Series User Guide
: 2000638 Rev. A
Network Redundancy | STP Port Configuration Page - 79
Configuration Using the Web User Interface
Network Redundancy | STP Port Configuration Page
The Spanning Tree Protocol as defined by IEEE 802.1D provides loop free topologies for any Local Area
Network (LAN). The Rapid Spanning Tree Protocol as defined by IEEE 802.1w is an evolution of the STP that
provides faster spanning tree convergence after a topology change.This page allows you to configure the port
parameter after you enable STP or RSTP.
Note:
You must
Save
) settings, if you want to maintain these settings if the WR7802-XT is rebooted.
STP Port Configuration
Port
This is the port number.
STP State
Enable or Disable the STP/RSTP of the port. The default is
Enabled
.
Use the
STP Configuration
page to enable and set the STP or RSTP mode.
Path Cost
Enter a number between 1 and 200,000,000. This value represents the cost of the
path to the other bridge from the transmitting bridge at the specified port. The
default value for 100Mbps ports is 200000. The default value for 1000Mbps ports
is 20000.
Priority
Enter a value between 0 and 240, using multiples of 16. This is the value that
decides which port should be blocked by priority in a LAN.
Version
