16 - Connect SFP Transceivers (Ports 3-4)
RocketLinx WR7802-XT Series User Guide
: 2000638 Rev. A
Hardware Installation
Connect SFP Transceivers (Ports 3-4)
The WR7802-XT provides two SFP ports that
accept standard mini GBIC DDM SFP
transceivers that support 100BASE-FX/
1000BASE-X.
To ensure system reliability, Comtrol
recommends using
1.
Plug the SFP transceiver into the SFP fiber
transceiver.
2.
Connect the transmit channel to the receive
channel at each end.
3.
Check the direction/angle of the fiber transceiver and the fiber cable.
Note:
This is a Class 1 Laser/LED product. Do not stare at the Laser/LED Beam.
The default speed setting is 1000Mbps. If you want to use a 100M SFP Fiber transceiver, you MUST change
the speed to 100Mbp in management interface first.
Multi-Mode cables should not exceed 2KM and Single-Mode cables should not exceed 30km.
Mount the WR7802-XT
You can use the following procedure to mount the WR7802-XT on a DIN rail or on the wall. The DIN rail clip
is already attached to the WR7802-XT. If the DIN rail clip is not screwed onto the WR7802-XT, follow the
instructions and the figure below to attach DIN rail clip to the WR7802-XT.
The SFP cage is 2 x1 design.
1.
Insert the upper end of DIN rail clip into the back of DIN rail
track from its upper side.
2.
Lightly push the bottom of DIN rail clip into the track.
3.
Verify that the DIN rail clip is tightly attached on the track.
4.
To remove the WR7802-XT from the track, reverse the steps
above.
DIN Rail Mounting
Beta
Version
