RocketLinx WR7802-XT Series User Guide
: 2000638 Rev. A
Power over Ethernet | PoE Control Page - 61
Configuration Using the Web User Interface
Port Configuration
Mode
Enable/Disable the port’s PoE function.
Powering Mode
IEEE 802.3af, 802.3at(2-event), and forced mode are supported.
Forced
mode ignores the classification behaviors and delivers power to the
connected device. When using
Forced
mode, be careful and verify that your
connected device can support the power that you configure.
Budget (W)
Assign the PoE budget of the port. The valid values range from 1~31W.
Power priority
You can set one of the three levels, Critical, High and low. If the system PoE
consumption is over the budget, the PoE system turns off the low priority
port first, then high and critical are the last.
PD Status Detection
Enable PD Status
Detection
You can detect the connected PD status. If the connected device is failing, the
system resets the PoE of the port as the first step to assist the field engineer.
IP address
The IP address of the connected PD of the port.
Cycle time(s)
This is the time reserved per duration of PD reboot in seconds, the range is
from 10~3600. You can measure the PD reboots duration time first.
Normally, an IP camera will take at least 40~50 seconds. Once you define
this function, the PoE router turns off PoE power when the connected PD
does not echo the request. After the cycle time, the PoE router starts the PD
again. This function also referred to as link partner line detection (LPLD).
Delete
Click
Delete
and
Apply
can delete the settings.
PoE Control (Continued)
Beta
Version
