Comtech EF Data Vipersat SLM-5650A, Installation And Operation Manual

Page: 114 / 516

SLM-5650A Satellite Modem
Revision 10
Front Panel Operation 7–8 MN-SLM-5650A
7.2.3 (SELECT:) Configure (Configuration) Menu Branch
CONFIG: Tx Rx Mode AUPC Transec
AntHndOvr Ref Mask Reset Remote (

E)
Use the

arrow keys to select a configuration submenu. Press [ENT] .
The Configure Menu Branch provides submenus for configuring the following modem operations:
Menu Branch Sect. Function
Tx (Transmit) 7.2.3.1
Use to configure, on a parameter-by-parameter basis, the Tx operation of the unit.
For example, use these submenus if you wish to change only the Tx Frequency.
This submenu is not accessible if modem operation has been set to Demod Only.
Rx (Receive) 7.2.3.2
Use to configure, on a parameter-by-parameter basis, the Rx operation of the unit.
For example, use these submenus if you wish to change only the Rx Frequency.
Mode 7.2.3.3
Use to configure the modem operational mode, frequency band, interface types
and their associated operating modes.
AUPC 7.2.3.4
Use to configure the Automatic Uplink Power Control functions. This menu is
selectable only if the “Modem Type” has been set to AUPC.
TRANSEC 7.2.3.5 Use to configure the optional TRANSEC (Transmission Security) Module features.
AntHndOvr 7.2.3.6
Use to configure the Antenna Handover features (when the SLM-5650A is used
with the CRS-311-AH Antenna Handover Switch). This menu is selectable only if
the Antenna Handover FAST option is installed.
Ref
(Reference)
7.2.3.7
Use to configure the internal 10 MHz Reference or allow the unit to phase lock to
an External Reference of 1, 5, or 10 MHz. The unit reverts to Internal if the
External Reference is not present or is faulted.
Mask 7.2.3.8 Use to configure how the modem handles alarms and faults.
Reset 7.2.3.9 Use to reset the modem to its factory configurastion settings.
Remote
(Remote
Control)
7.2.3.10 Use to configure whether the unit is being controlled locally or remotely.
The modem may be monitored over the remote control bus at any time. When
in Local mode, however, configuration parameters may only be changed
through the front panel. Conversely, when in Remote mode, the unit may be
monitored from the front panel, but configuration parameters may only be
changed via the remote control bus.