Comtech EF Data Vipersat SLM-5650A, Installation And Operation Manual

Page: 227 / 516

SLM-5650A Satellite Modem
Revision 10
Serial Remote Control 10–33 MN-SLM-5650A
Parameter
Type
Controller-to-Target
Instruction Code and
Qualifier
Arguments
for Command
or Query
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 to 57)
Target-to-Controller
Command Query
Response to
Command
Response to Query
(see Description of
Arguments)
Clear All Stored
Statistics
CAS= N/A None Command only.
Forces the firmware to clear the Stored Statistics log.
Note: This command takes no arguments.
CAS=
CAS?
CAS*
CAS#
N/A
CnC Frequency
Offset Range
CCF= CCF? 6 bytes Command or Query.
Sets or returns the CnC Sweep Frequency in the form xx.xxx, where:
xx.xxx = Frequency value in the range from 0 to 60.000 kHz
Example: <0001/CCF=60.000{CR}{LF}
CCF=
CCF?
CCF*
CCF#
CCF=xx.xxx
CnC Delay
Monitor
N/A CDM? 6 bytes Query only.
When CnC is enabled and locked, returns the delay of the interferer is
readable in microseconds.
Example 1: >0001/CDM=229500{CR}{LF} (229.5 µs)
Example 2: >0001/CDM=999999{CR}{LF} (not locked or CnC not
enabled)
N/A CDM=xxxxxx
CnC Frequency
Offset Monitor
N/A CFM? 6 bytes Query only.
When CnC is enabled and locked, returns the estimated frequency
offset between the desired signal and the interferer is readable in
kHz.
Example 1: >0001/CFM=+001.0{CR}{LF} (1 kHz)
Example 2: >0001/CFM=9999.9{CR}{LF} (not locked or CnC not
enabled)
N/A CFM=xxxx.x