Comtech EF Data Vipersat SLM-5650A, Installation And Operation Manual

Page: 153 / 516

SLM-5650A Satellite Modem
Revision 10
Front Panel Operation 7–47 MN-SLM-5650A
7.2.7.6 (UTIL:) Agc (Automatic Gain Control)
AgcMon: Min Value: 00.0 Volts
Max Value: 10.0 Volts (

E)
Use this submenu to set the minimum and maximum voltage levels for the external AGC monitor
voltage that is available through the rear panel ‘J9 Auxiliary’ connector.
Use the

arrow keys to select Min Value or Max Value . Press [ENT] . Note that:
•
Min Value specifies the voltage to output on the External AGC voltage signal when the
demodulator RSL is at its minimum level.
•
Max Value specifies the voltage to output when the demodulator RSL is at its maximum
level.
To edit either value, use the

arrow keys to select a digit, and then use the

arrow keys to
change that digit. Press [ENT] .
7.2.7.7 (UTIL:) Alarm
Audible Alarm: Disable Enable
(

E)
Use the

arrow keys to either Disable or Enable the alarm. Press [ENT] .
7.2.7.8 (UTIL:) PwrCal
Burst L-Band Pwer Cal: The modem will
Be (re)calibrated. Continue? No Yes
To execute calibration of the L-Band board for burst operation, use the

arrow keys to select
Yes . Press [ENT] .
7.2.7.9 (UTIL:) Firmware
Firmware Images: Information
Select (

E)
Use the

arrow keys to select Information or Select . Press [ENT] .
(UTIL:) Firmware

Information
Firmware Info: Bootrom Image#1
Image#2 (

E)
This menu permits you to view information on the firmware and software used by the
modem. Use the

arrow keys to select Bootrom , Image#1 , or Image#2 .