Comtech EF Data Vipersat SLM-5650A, Installation And Operation Manual

Page: 138 / 516

SLM-5650A Satellite Modem
Revision 10
Front Panel Operation 7–32 MN-SLM-5650A
(CONFIG:) Remote

EthernetConfig

Gateway
Ethernet Default Gateway IP Address:
192.168.001.001 (

)
The IP Gateway Address is the default address that the modem will send all IP responses when
the message originated from a source outside the modems local attached network. To enter the
Gateway IP Address, use the

arrow keys to select a digit, and then the

arrow keys to
change that digit. Press [ENT] .
7.2.3.10.1 (CONFIG:) Remote

EthernetConfig

SNMP
SNMP is NOT supported by the TRANSEC module.
For modems running Base Modem Firmware Version 1.4.6 or higher, the base
modem management can be changed to secure mode by changing the SNMP
Version setting from SNMPv1/v2c to SNMPv3. Make sure to carefully read the
operational restrictions described in this section when selecting your SNMP
Version as SNMPv3.
SNMP: Version Communities Traps
(

E)
Use the

arrow keys to select Version , Communities , or Traps . Press [ENT] .
(CONFIG:) Remote

EthernetConfig

SNMP

Version
SNMP Version: SNMPv1v2c SNMPv3
(

E)
Use the

arrow keys to select SNMPv1v2c or SNMPv3 . Press [ENT] .
After you select SNMPv3 and reboot the modem, access to the HTTP and
Telnet interfaces will be blocked. This operational change also forces the
Trap Version to be SNMPv3. Change of the management mode to SNMPv3 is
allowable via the HTTP (non-secure) interface, but you should be aware that,
after the modem reboot, HTTP access will no longer be available. SNMPv3
operation uses the Base Modem’s IP Address via the ‘J5 Ethernet’ port. The
Base Modem HTTPS (secure) Interface is accessible by the TRANSEC IP
Address.
(CONFIG:) Remote

EthernetConfig

SNMP

Communities
SNMP Communities: Read Write
(

E)
Use the

arrow keys to select Read or Write . Press [ENT] .