Comtech EF Data Vipersat SLM-5650A, Installation And Operation Manual

Page: 136 / 516

SLM-5650A Satellite Modem
Revision 10
Front Panel Operation 7–30 MN-SLM-5650A
7.2.3.10 (CONFIG:) Remote
Remote Control: Mode:Serial
SerialConfig EthernetConfig (

E)
Use the

arrow keys to select Mode , SerialConfig , or EthernetConfig . Press [ENT] .
(CONFIG:) Remote

Mode
Use the

arrow keys to select Local , Serial , or Ethernet . Press [ENT] .
Local mode limits your access to remote operations. You may only
monitor the status of the modem.
(CONFIG:) Remote

SerialConfig
Remote Control: Interface Format
Baudrate (

E)
For serial communications , use the

arrow keys to select Interface , Format , or Baudrate .
Press [ENT] .
(CONFIG:) Remote

SerialConfig

Interface
M&C Bus Interface: RS232 RS485-2W
RS485-4W TTL(Switch) CRS-500 (

E)
Use the

arrow keys to select RS232 , RS485-2W (2-wire), RS485-4W (4-wire), TTL
(Switch) , or CRS-500 . Press [ENT] .
When you select RS-232, the local M&C Bus Address displays 0000.
Addressing is not supported by RS-232 or TTL (Switch) because they
are not multi-drop communication standards.
If you select RS-485, the display will show address 0001 to 9999. This
address can be changed using the front panel. The most significant
digit is for Comtech EF Data redundancy switches.
If you select TTL (Switch), this enables interoperation with the CRS-311
(1:1) or CRS-300 (1:N) redundancy switches.
With RS-232 Selected:
Local M&C Bus Address:
0000
With RS-485 Selected:
Local M&C Bus Address:
0001