Club Car CARRYALL 252 2007, Maintenance And Service Manual

Page: 455 / 536

IQ DISPLAY MODULE (IQDM) SERIES 2 AND
IQDM-P DIAGNOSTICS
Test Procedures
23
2 – Handset Cord Adaptor
3 – IQDM Jacks
4 – IQDM Jack (Located Under the Instrument Panel)
5 – IQDM Jack (Speed Controller)
TEST PROCEDURE 1 – Handset Cord
See General Warning on page 1-1.
1. Using a multimeter set for 200 ohms, place the red (+) probe into one of the terminals on the end of the cord with
the square plug.
2. Place the black (–) probe on each of the pins, one at a time, on the plug on the other end of the cord.
3. The multimeter should indicate continuity on only one pin. If any other reading is obtained, the cord must be
replaced.
4. Repeat the procedure three more times, each time with the red (+) probe inserted into a different terminal on
the end of the cord with the square plug.
TEST PROCEDURE 2 – Handset Cord Adaptor
See General Warning on page 1-1.
The procedure for testing the handset cord adaptor is similar to the cord test.
1. Using a multimeter set for 200 ohms, place the red (+) probe into one of the terminals on the end of the adapter
with the square plug.
2. Place the black (–) probe on each of the pins, one at a time, on the other plug of the adaptor.
3. The multimeter should indicate continuity on only one pin. If any other reading is obtained, the adaptor must
be replaced.
4. Repeat the procedure three more times, each time with the red (+) probe inserted into a different terminal on the
end of the adaptor with the square plug.
TEST PROCEDURE 3 – IQDM Jacks
See General Warning on page 1-1.
NOTE: The locations of the IQDM Jacks and speed controller vary based on model, year model, and options. If the
IQDM Jack is located under the instrument panel, see Test Procedure 4 – IQDM Jack (Located Under
the Instrument Panel) on page 23-21 . To test directly at the speed controller, see Test Procedure 5 –
IQDM Jack (Speed Controller) on page 23-22 .
TEST PROCEDURE 4 – IQDM Jack (Located Under the Instrument Panel)
See General Warning on page 1-1.
1. Turn the key switch to the OFF position, place the Forward/Reverse switch in the NEUTRAL position, and
lock the park brake.
2. Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles,
Section 1, Page 1-4.
3. Check the IQDM jack mounted under the instrument panel.
3.1. Remove the center dash panel (Figure 23-7, Page 23-22) .
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual Page 23-21