23
Functions Menu
IQ DISPLAY MODULE (IQDM) SERIES 2
AND IQDM-P DIAGNOSTICS
WRITE SETTINGS TO CONTROLLER
This function transfers all of the speed controller settings (except for “private speed mode”) from the handset to the
vehicle speed controller. This enables the trained technician to “clone” a speed controller. Once the speed controller
settings have been transferred to the handset, the technician can then connect the handset to another vehicle and
transfer the stored settings into the speed controller.
Speed Controller Cloning – Transferring Settings from the Handset to the Vehicle
1.
Perform this procedure with a handset that has the desired speed controller settings.
Cloning – Transferring Settings from the Vehicle to the Handset on page 23-14.
2.
Locate a vehicle that does
not
have the desired speed controller settings.
3.
Turn the key switch to the OFF position, place the Forward/Reverse handle in the NEUTRAL position, and
lock the park brake.
4.
Plug the handset into the vehicle.
4.1. Connect one end of the cable to the jack located on the bottom of the handset.
4.2. Connect the cable adaptor to the IQDM cable.
4.3. Remove the dust cap from the IQDM jack.
4.4. Align the keyed portion of the plug with the IQDM jack and connect the plug to the jack
.
5.
Scroll to the
functions
menu and select.
6.
Select
settings
.
7.
Select
write settings to controller
.
8.
Press + on the change value button to confirm the operation.
9.
The handset will display an “executing...” message for the next few seconds while the controller settings are being
stored in the handset’s memory
10. When the handset is finished transferring the speed controller settings, a confirmation message is displayed
11. Repeat this procedure for additional vehicles that need to be programmed with the same handset settings.
Page 23-16
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
