14
Key Switch
ELECTRICAL COMPONENTS: PEDAL-
START GAS VEHICLE
2.
Remove the center dash panel.
2.1. Remove the plastic cap (1) covering the mounting screw (2) on each side of the center dash panel (3)
.
2.2. Loosen, but do not remove, the screw (2) on each side of the center dash panel (3).
2.3. Insert screwdriver at the top center of the dash between dash and cowl brace. Gently pry center dash out
slightly from under edge of cowl brace.
2.4. Pull center dash out from the frame and disconnect the wires from the electrical components mounted on
the dash panel. Do not allow wires to touch.
See following NOTE.
NOTE:
Take care to prevent key switch terminals and wires from touching the metal frame around the dash.
2.5. Slide center dash panel up the steering column.
1
2
3
516
Figure 14-16
Center Dash Panel Removal
3.
Disconnect the wires from the key switch.
4.
Remove the key switch:
4.1. Remove the key switch cap with a small, flat-blade screwdriver.
4.2. Remove key switch (2) from the dash by holding the key switch and turning the nut (1) on the outside of the
dash with a 1-inch socket wrench
. Remove the keyed washer with key switch.
1
2
502
Figure 14-17
Key Switch Removal
Page 14-14
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
