Club Car CARRYALL 252 2007, Maintenance And Service Manual

Page: 135 / 536

TROUBLESHOOTING AND ELECTRICAL SYSTEM:
KEY-START WITH NEUTRAL REV GAS VEHICLE Test Procedures
11
If the reading is incorrect, clean and tighten wire connections. If the connections are good and the reading
is incorrect, repair or replace the wire.
4. Check the engine ground strap.
4.1. Place the red (+) probe of the multimeter on the ground strap terminal end located on the oil filler bracket on
the engine (Figure 11-6, Page 11-13) . Place the black (–) probe on the vehicle frame. The reading should
be continuity. If the reading is incorrect, clean and tighten wire connections. If the connections are good
and the reading is incorrect, repair or replace the wire.
F2
1
2
1. Ground to Chassis
2. A2 Terminal
00
00
Place test probes at each end of ground cable.
Figure 11-5 Test Starter/Generator Ground Strap Figure 11-6 Test Engine Ground Strap
5. Check voltage regulator ground connection (at battery frame ground). Make sure it is clean and tight.
6. Check the battery ground cable.
6.1. A 6-gauge black wire connects the negative battery post to the frame. The frame connection should be
clean and tight. Visual inspection of the connection on the frame is very difficult. The best check for
tightness is to pull on the black wire. If the wire moves at the connection end, disassemble the frame
connection and clean the bolt, ring terminal, and nut. Install the frame connection.
6.2. Set the multimeter to 200 ohms. Place the red (+) probe on the unconnected end of the 6-gauge black
wire, and place the black (–) probe on the vehicle frame (Figure 11-7, Page 11-13) . The reading should be
continuity. If the reading is incorrect, check that terminal connections are clean and tight. If the connections
are good and the reading is incorrect, repair or replace the wire.
2m
20
m
200
m
2k
200
200
200 200
20
2
200
m
500
20k
200k
2000
k
1000
OFF
WAVETEK 5XL
V
V
V
A
! !
COM
200nA
MAX
1000 ---
750V
FUSED
2
3
1
1. Disconnect the 6-gauge black wire from the battery. Place red
(+) probe on disconnected end of cable.
2. Place black (–) probe on frame.
Figure 11-7 Battery Ground Cable Test
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual Page 11-13