Club Car CARRYALL 252 2007, Maintenance And Service Manual

Page: 309 / 536

S10 FE 350 FUEL SYSTEM Engine Control Linkage
17
1
2
3
539
Figure 17-6 Accelerator Rod
Accelerator Rod Installation and Adjustment
1. Before installing the accelerator rod, adjust accelerator pedal position. See Pedal Group Adjustment –
Gasoline Vehicles on page 5-10.
2. Install the ball joint on the ball stud at the accelerator pedal (Figure 17-6, Page 17-7) .
3. Access the engine compartment.
4. Remove the electrical box screw and cover (Figure 17-7, Page 17-8) .
5. Adjust length of accelerator rod. With the ball joint jam nuts (3) loose (Figure 17-6, Page 17-7) , adjust the
length of the accelerator rod so the indicated cam edge is parallel with the electrical component box as shown
(Figure 17-7, Page 17-8) . See following CAUTION.
CAUTION
• Be sure that approximately an equal number of threads are exposed at each end of the accelerator rod.
6. Install the accelerator rod on the bell crank ball joint on the electrical component box (Figure 17-8, Page 17-8) .
See following CAUTION and NOTE.
CAUTION
• Inspect the limit switch inside the electrical box. If the limit switch lever is bent, replace the switch.
NOTE: Use the inside hole location, or hole closest to the bell crank shaft as shown (Figure 17-8, Page 17-8) .
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual Page 17-7