Club Car CARRYALL 252 2007, Maintenance And Service Manual

Page: 50 / 536

5
Accelerator Pedal – Electric Vehicles ACCELERATOR AND BRAKE PEDAL GROUP
3. Remove the MCOR (2) and drive bar (3) as instructed (Figure 5-7, Page 5-9) . See MCOR Removal on page
24-6.
4. Use a 9/16-inch socket and 9/16-inch wrench to remove the nut (7), two washers (5), and bolt (4) securing the
accelerator pedal (1) to the pivot rod (6)
(Figure 5-7, Page 5-9) .
5. Remove the nut (10) and bolt (8) from the accelerator pivot rod assembly (6).
6. Slide the spring retainer (11) off of the accelerator pivot rod.
7. Inspect the pivot support bearing (9) for wear and replace if necessary.
8. Use a marker to mark the position of the park brake ratchet (24) on the accelerator pivot rod (6). See following
NOTE.
NOTE: Failure to mark position of the ratchet could cause it to be installed improperly, resulting in improper adjustment
and possible failure of the park brake.
9. Remove the lock nut (23) from the accelerator pivot rod.
10. Press the brake pedal slightly and slide the park brake ratchet (24) toward the end of the accelerator pivot rod.
Rotate the ratchet and remove it from the pivot rod.
11. Remove the pivot rod (6) and spacer (20) from the accelerator pivot rod supports (21) (Figure 5-7, Page 5-9) .
12. Inspect the accelerator pivot rod supports (21) for wear and damage and replace as necessary. If the pivot
rod supports do not require replacement, loosen, but do not remove, the four bolts (22) and lock nuts (15) to
make installation of the pivot rod easier.
13. Remove the accelerator pedal (1) from the vehicle (Figure 5-7, Page 5-9) .
14. Inspect all parts for wear and damage. Replace as necessary.
Page 5-8 2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual