4
Front Body
BODY AND TRIM
1.1.
Vehicles without heavy-duty bumper:
Remove blind rivets (10).
2.
Vehicles equipped with a heavy-duty front bumper (1):
2.1. Remove the two carriage bolts (5), lock nuts (3), and spacers (4) from the heavy-duty bumper mounting
positions located on both sides of the front body.
2.2. Remove carriage bolts (2) and lock nuts (3) from the heavy-duty bumper support braces and remove
bumper.
3.
Remove carriage bolts (15), lock nuts (17), and washers (16) from front body trim. Remove screws (14) from
top of front body.
4.
Loosen, but do not remove, screws (18) holding front body trim against front body.
5.
Vehicles equipped with headlights:
Disconnect the light wiring harness from the headlight assemblies.
6.
Pull front body (12) from under trim (13) and remove from vehicle.
1
13
14
11
12
6
17
16
15
18
19
5
3
4
2
3
9
8
10
9
8
B
A
Detail A. Front Bumper
Detail B. Heavy-Duty Front Bumper
Figure 4-1
Front Body Assembly
FRONT BODY INSTALLATION
1.
Install front body (12) under trim (13), align holes and finger-tighten screws (14) holding front body against
frame
2.
Install carriage bolts (15), washers (16), and lock nuts (17) onto front body trim. Tighten bolts to 11 ft-lb (14.9
N·m). Tighten screws (14) to 20 in-lb (2.3 N·m).
See following NOTE.
Page 4-4
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
