Club Car CARRYALL 252 2007, Maintenance And Service Manual

Page: 314 / 536

17
Choke and Air Intake System S10 FE 350 FUEL SYSTEM
CHOKE AND AIR INTAKE SYSTEM
See General Warning on page 1-1.
GENERAL INFORMATION
The choke system is a simple mechanism requiring very little or no maintenance. The system consists of a choke
assembly that is attached to the driver side of the front body, an air filter housing with a hose that is attached to the
carburetor, and an air duct that provides the engine with air from outside the engine compartment. Clean, cool air
is drawn through the choke assembly and into the air cleaner intake. This feature increases engine horsepower
and extends air filter life.
The choke system aids in starting the engine in cold weather. When starting a cold engine, the choke cable handle is
pulled. This restricts the air flow, creating a “fuel rich” mixture in the carburetor. The choke cable handle is pulled
until the engine starts, and then is released. The air flow to the engine is no longer restricted, and the engine
operates normally.
The choke assembly is adjusted at the factory and does not require field adjustment; however, if the choke assembly is
subjected to abuse or damaged, it may become necessary to replace the assembly.
CHOKE CABLE REMOVAL
1. Turn the key switch to the OFF position and remove the key, place the Forward/Reverse handle in the NEUTRAL
position, and chock the wheels.
2. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles, Section
1, Page 1-3.
3. Remove the screw (17) securing cable to air box and detach cable end from choke lever (6) (Figure 17-12,
Page 17-15) .
4. Remove three screws (19), nuts (21) and washers (20) from body and remove choke cable assembly from
body
(Figure 17-12, Page 17-15) .
CHOKE CABLE INSTALLATION
1. Insert choke cable through hole in body until choke lever assembly seats against body.
2. Install three screws (19), washers (20), and lock nuts (21) as shown and tighten to 18 in-lb (2.0 N·m) (Figure
17-12, Page 17-15) .
3. Check the hex nut on the cable at the back of the choke lever assembly. If it is loose, tighten it until the lock
washer beside it collapses completely.
4. Attach choke cable to choke lever (6) on air box. Install screw (17) to secure cable to air box and tighten to 18
in-lb (2.0 N·m)
(Figure 17-12, Page 17-15) .
5. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline Vehicles, Section 1, Page 1-3.
AIR BOX REMOVAL
1. Turn the key switch to the OFF position and remove the key, place the Forward/Reverse handle in the NEUTRAL
position, and chock the wheels.
Page 17-12 2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual