43
FieldSmart
®
Fiber Active Cabinet (FAC) 3200
__________________________________________________________
Installation Manual
Direct: 763.476.6866 • National: 800.422.2537 • www.SeeClearfield.com • [email protected]
Manual 020421 REV A - Jan 2019
Remove the two left-side lifting eyebolts from the cabinet roof (opposite the splice compartment).
Attach the top bracket to the cabinet roof as follows:
a.
Position the top bracket on the roof, aligned with the two vacant eyebolt holes.
b.
Insert (2) 1/2-inch hex screws (with flat and lock washers) into the threaded holes.
c.
Tighten the screws completely to secure the bracket in place.
Secure the top bracket to the pole as follows:
a.
Install the two steel bolt-a-bands through the slots
in the top bracket, around the pole, and back into
the band retainers
b.
Pull the bands tight (to 20 ft-lbs.) and tighten the
nut on each bolt to secure it in place.
Step 1:
Step 2:
Step 3:
To install the top bracket
Attach the rear mounting bracket to the base assembly as
follows:
a.
Position the rear mounting bracket against the opposite side of
the pole, fitting the (4) threaded rods through the counterpart
holes in the rear bracket.
b.
Loosely install a 1/2-inch flat washer, lock washer, and nut
onto each rod.
c.
Verify that the bracket is level, and then drill (3) 3/8-inch pilot holes into the pole through the holes in the center of
the rear bracket.
d.
Install (3) 1/2 x 3-inch lag screws into the pilot holes to attach the rear bracket to the pole. Tighten the screws
completely to secure the bracket in place.
Verify that the base platform is level, and then tighten all hardware to secure the assembly in place.
Perform the following task only after the cabinet is installed on the mounting fixture.
Completing the fixture installation requires installing the top bracket on the cabinet roof and securing it to the
pole. See
Installing the Cabinet on a Pole
for instructions before continuing.
Step 3:
Step 4:
