79
SMARTFLOW II
Rotary Dial Functions (Cont.)
NOTE:
The Application Rate display window will always match the Rate displayed in the Data display
window except for the following:
• Displays Target Rate for 3 seconds when the Rate Toggle switch is changed and the “FILL” message
does not alternate with it.
• Alternate between “Lo” and “SPEEd” when in VARIABLE mode (and not PCOFF) if the speed
is below “min Speed”, and it will alternate between “hi” and “SPEEd” if the speed is above
“Max Speed: cal factor. This will take precedence over the 3 second display of Target Rate.
• Displays “OFF” when in OFF mode or display “PCOFF” if PC issued an Off command by sending
0. “OFF” takes precedence over “PCOFF” and both take precedence over the “Lo/Hi Speed”
and “OFL” messages.
If some error occurs “Err 1” – “Err 4” will display and take precedence over the above messages
(OFF, PCOFF, OFL, FLUSH and Hi/Lo SPEEd). (See Error Codes section for details).
• It will alternate “FILL” when the Tank level is low and these messages: OFF, PCOFF, OFL, ErrX.
(FILL is not displayed when it’s alternating between “Lo/Hi and SPEED”.)
• The MAN icon is on when in CONTINUOUS mode and the AUTO icon is on when n VARIABLE mode.
• A number icon 1,2,3 will turn on, based on the rate selected with the Rate Toggle switch. When
in PCCC mode, these numbers will be off. This will remind the user the SmartFlow II is under PC
control and it’s using a Target received from the PC rather than Target Rate 1, 2 or 3.
The Application Rate display is blank during power up when the SmartFlow II Hours and REV level
are displayed.
CONTROL PANEL FUNCTIONS