20
PRO-MIST DURA® ULV
Sleeve Removal and Replacement (Cont.)
Position the Spanner Puller tool
over the flange of the Hub and turn
the thumb screw on the tool to pop
the Hub free from the Shaft. If very
stuck grab thumb screw with pliers.
4
Carefully remove the Hub from
the Shaft. Be careful not to drop
or damage the Hub. It is critical it
remains balanced and round. NEVER
run a damaged or out of balance Hub.
Locate the posts of the Spanner
Puller tool into the sockets of the
Retaining ring.
The retaining Ring is secured
to the Hub with a Left Handed Thread.
It is important to remember to rotate
CLOCKWISE to loosen.
Secure the Spanner Base plate
to the work bench, truck bed, or
machine base. Locate the sockets on
the bottom brim of the Hub onto the
posts of the base plate. This will hold
the Hub from spinning when loosening
the retaining ring.
6
5
7
8
Remove the Used Sleeve, it should slide
off easily.
9
8
4A
SPRAYER MAINTENANCE
NOTE:
The base plate (as shown in picture 6)
can be purchased separately: Part #332742
OR
Hub can be secured to the blower Stand.
Affix two small screw heads where indicated in
picture 4A.