41
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-08
Chapter
Caveats in Cisco IOS XE 3.7S Releases
Symptom:
The active RSP displays traceback error messages occurring on the standby RSP.
Conditions:
Occurs with the following configuration:
–
The router is configured with 1000 multicast groups
–
The outgoing interface is a bridge-domain interface (BDI)
–
All hosts are receiving a high rate of traffic.
The issue occurs after you issue a stateful switchover (SSO).
Workaround:
Avoid performing an SSO with the configuration described.
•
CSCud33906
Symptom: Equal Cost Multipath (ECMP) loopback does not function properly.
Conditions: Occurs when a port-channel link dynamically assigned as an ECMP path.
Workaround: There is no workaround.
•
CSCud34346
Symptom:
The router crashes.
Conditions:
The issue can occur when:
–
The router is configured with multiple ECMP paths
–
MPLS IP is not enabled on one of the ECMP paths
Workaround:
There is no workaround.
•
CSCud38038
Symptom:
The router records incorrect delay measurements after a reload.
Conditions:
Occurs under the following conditions:
–
You configure Delay Measurement Message (DMM) on a port-channel interface.
–
The port-channel member links are on different interface modules (IMs).
–
You reload the router.
Workaround:
You can use the following workarounds:
–
Remove the
ethernet cfm global
command and re-apply it after the port-channel member links
recover.
–
Configure PTP clock synchronization.
•
CSCud38115
Symptom:
OSPF connections flap and drop traffic for approximately 20 seconds
Conditions:
Occurs during stateful switchover (SSO).
Workaround:
There is no workaround.
•
CSCud38419
Symptom:
The router crashes when you apply an access control list (ACL) configuration. The issue
occurs rarely and when the router is configured at a high scale.
Conditions:
Occurs when:
–
You create and apply IPv6 ACLs
–
You remove the IPv6 ACLs
–
You replace the IPv6 ACLs with IPv4 ACLs