Christie VeinViewer Flex, User Manual

Page: 21 / 76

CHAPTER FOUR: VEINVIEWER FLEX SETUP 15
VEINVIEWER FLEX USER GUIDE
020-300020-03 Rev. 1 (03-2013)
Battery Charger
1. Unwrap the AC Power Adapter and connect the Battery Charger output plug
to the 9V jack on the back of the charger.
2. Insert the pronged plug into a wall receptacle.
3. Match the grooves on the end of the Battery to the grooves in the Battery
Charger cradle and insert the Battery into the Battery Charger; the battery
should snap in place. The LED indicator on the Battery Charger will blink
indicating the Battery is charging.
4. The Charger Status Indicator will illuminate solid green when the Battery is
fully charged.
9V Inlet - Wall Outlet
12V Inlet - Car Outlet
1 2
11
22
INSTALLING THE BATTERY
1. Rotate the Battery Door Lock counterclockwise to access the battery
compartment.
2. Match the grooves on the end of the Battery to the grooves in the battery
compartment.
3. Press the Battery completely into the battery compartment. Once the Battery
is fully seated, an audible snap will be heard.
4. Close the Battery Door.
5. Rotate the Battery Door Lock clockwise until it stops.
The estimated Battery life is up to approximately 2 hours of
continuous run time when fully charged. Recharge time is estimated
at approximately 4 hours.
When powered off with the Battery installed, VeinViewer Flex enters a
low-power stand-by mode, which will drain the Battery over
approximately 72 hours. To maintain battery charge over extended
periods, remove the Battery from the device.
The Status Indicator will blink three times, when the Battery is installed
and when the AC Power Adapter in not connected.