Canon iPR C7010VP Series, Installation Manual

Page: 119 / 157

Chapter 2
2-74
2.1.9.4 Primary Inner Delivery Unit / Primary Fixing
Intermediate Unit (9 million prints)
0026-4616
imagePRESS C6010 / imagePRESS C7010VP / imag ePRESS C6010VP /
imagePRESS C7010VP FS / imageP RESS C7010VP PSU / imagePRESS
C6010VP FS / imagePRESS C6010VP PSU / imagePRESS C6010 FS / im-
agePRESS C6010 PSU
1. Parts to replace
- Inner delivery unit
- Fixing intermediate unit
2. Before the replacement
5) Moisten the cleaning paper packed with the new fixing belt unit with
alcohol solutions, and clean the whole circumference of the fixing belt
surface [A] while rotating the gear [1] of the fixing belt unit with hand.
CAUTION:
Be sure to use the cleaning paper packed with the unit for cleaning.
CAUTION:
Note the following points when disassembling the Fixing Assembly.
- Be sure to start the work after the Fixing Assembly gets cold enough to
prevent burn injury.
- When the External Heat Pressure Plate [1] is engaged with the Fixing
Assembly, the gear [2] of the Fixing Assembly may rotate and catch a
finger, so do not touch the gear [2] of the Fixing Assembly.
[1]
[1]
[A]
CAUTION:
When removing the Fixing Upper Front Cover, be sure to check the
position of the Sensor Flag [1].
If the Sensor Flag is at the position [2], the Fixing Assembly cannot be
disassembled/ assembled because the Fixing Assembly is under pressure.
Follow the following steps to release the pressure of the Fixing Assembly.
1) Install the Fixing Upper Front Cover.
2) Put the Fixing Assembly in the host machine.
3) Close the Sub Station Right Front Cover.
4) Close the Sub Station Left Front Cover.
5) Turn OFF and then ON the power.
[2]
[1]
[2]