6. Troubleshooting
- 5 -
*
3
Channel setting guidelines
Wireless LAN channel setting guidelines for adding the DR Wireless system to an environment
where another wireless LAN is already in use are described below. These guidelines apply to both
the 2.4 GHz and 5 GHz bands.
Existing wireless LAN system
HT40 HT20
CXD
I-70C / CXD
I-80C
HT40
(1) Set channels that do not interfere
with each other.
*
1
(2) Use the same setting for the
primary and secondary channels.
(3) Use the same setting for the
primary channel only.
*
2
(1) Set channels that do not interfere with each
other.
(2)
Use the same setting for the primary
channel as the channel setting of the other
wireless LAN system.
H
T
20
(1) Set channels that do not interfere
with each other.
(2) Use the same setting as that of the
primary channel of the other
wireless LAN system.
(1) Set channels that do not interfere with each
other.
(2) Use the same channel settings.
*1
: In the 2.4 GHz band it is not possible to specify two noninterfering channels in HT40.
*2
: In the 5 GHz band the channel pairs are predetermined and there is no way to set the same
primary channel only. In contrast, in the 2.4 GHz band it is possible to specify either of two
channels for each primary channel, such as 6CH below 2CH or 6CH above 10CH.
Summary of Contents for CXDI-80C
Page 6: ...Note These measurements are only guidelines ...
Page 10: ...1 1 O Ov ve er rv vi ie ew w 2 2 System diagram ...
Page 48: ...2 Installation procedures 15 4 Handle unit option Corner pads Outer box Inner box ...
Page 133: ...Rev 01 CONTENTS Detector unit 1 X ray interface box unit 2 Wiring unit 4 Handle unit 6 ...
