4. Repair Guide
- 6 -
3.2.2.2 Mounting the PCA-XIF board
1) Insert the LAN cable connector, AC adapter connector (DC inlet) and LED of the PCA-XIF
board through the holes in the base, and lay the PCA-XIF board flat.
* The shielded plate that covers the LAN cable connector is made electrically conductive
with the edge by pushing it into the hole in the base.
2) Using the DC inlet position as reference, adjust the position of the PCA-XIF board.
* The end of the DC inlet must protrude by about 0.1 mm from the base wall.
3) Secure the PCA-XIF board using the eight screws (XB1-2300-606).
Reference:
Tightening torque: 58.8 N-cm (6 kgf-cm)
PCA-XIF board
X-ray interface box base
DC inlet
Wall of X-ray interface box base
Protrusion amount: Approx. 0.1 mm
XB1-2300-606 screws (x 8)
Summary of Contents for CXDI-80C
Page 6: ...Note These measurements are only guidelines ...
Page 10: ...1 1 O Ov ve er rv vi ie ew w 2 2 System diagram ...
Page 48: ...2 Installation procedures 15 4 Handle unit option Corner pads Outer box Inner box ...
Page 133: ...Rev 01 CONTENTS Detector unit 1 X ray interface box unit 2 Wiring unit 4 Handle unit 6 ...
