4. Repair Guide
- 8 -
3.3.2 Removing the cosmetic cover
Remove the four M3L6 brazier head hexagon socket bolts (XA9-2036) on the front panel of the
AC/DC box, and remove the cosmetic cover of the box.
* By removing the cosmetic cover, it is possible to access the screws used to make the
connection between the AC/DC power supply and AC/DC box base.
Reference:
Tightening torque: 58.8 N-cm (6 kgf-cm)
3.3.3 Removing the inside cables
1) Disconnect the AC socket cable connector from the AC/DC power supply.
2) Detach the power cable assembly that connects the AC/DC power supply and PCA-PB board,
disconnect the connectors at both ends of the cable, and remove the cable.
3) Remove the screw (XB1-2300-806) used to fasten both the cable clamp and the PCA-PB
board.
* Do not pull the cables free in order to disconnect the connectors.
XB1-2300-806（x 1）
Screw used to fasten
cable clamp (and board)
as seen from above
Cable tie as seen from view A
View A
AC/DC box base
M3L6 brazier head hexagon socket bolts
(XA9-2036) (x 4)
Cosmetic cover
AC/DC power supply
AC socket cable
PCA-PB board
Power cable assembly
XB1-2300-806 screw (x 1)
PCA-PB board
AC/DC
power
supply
Cable clamp
Tie the cables together from
above the protective tube.
Summary of Contents for CXDI-80C
Page 6: ...Note These measurements are only guidelines ...
Page 10: ...1 1 O Ov ve er rv vi ie ew w 2 2 System diagram ...
Page 48: ...2 Installation procedures 15 4 Handle unit option Corner pads Outer box Inner box ...
Page 133: ...Rev 01 CONTENTS Detector unit 1 X ray interface box unit 2 Wiring unit 4 Handle unit 6 ...
