1
1
.
.
O
O
v
v
e
e
r
r
v
v
i
i
e
e
w
w
- 4 -
3.2 System compatibility with CXDI-70C Wireless
The CXDI-80C Wireless uses the same system components as the CXDI-70C Wireless, as shown
below.
3.3 Restrictions on connections
The control software that can be connected to the product is Ver.1.40 and up. The number of units
which can be connected is restricted as below by the software requirements.
Registered units: 10, simultaneously connected units: 4
The hardware requirements do not impose restrictions, but communication performance may be
degraded by interference when wireless channels are shared.
No such restrictions apply to wired connections.
◆
Handling of ferrite cores
(1)
[70C Wireless (2.4 GHz compatible)]
The system conforms to IEC 60601-1-2 when ferrite cores are attached to the detector cable and to the
LAN cable used to connect to the X-ray interface box.
It is therefore necessary to attach ferrite cores to these two cables in order to use the system.
(2)
[70C Wireless (2.4 GHz/5 GHz compatible)]
The system conforms to IEC 60601-1-2 when no ferrite cores are attached to the sensor cable and to the
LAN cable used to connect to the X-ray interface box.
It is therefore not necessary to attach ferrite cores to these two cables in order to use the system.
Note: Caution on mixed usage of different detector models
If any of the detectors used is the 70C Wireless (2.4 GHz compatible) model, ferrite cores must be
attached to the two cables.
X-ray I/F Box
IR Data
Communication Unit
HUB
LAN (20m)
LAN
LAN
USB
IF Cable (20m)
Operation Unit
Sensor
Battery Pack
X-ray Generator
(< 5m)
(1.8m)
(1.8m)
(2.3m)
Access Point
80C Detector Unit
70C Detector Unit
Summary of Contents for CXDI-80C
Page 6: ...Note These measurements are only guidelines ...
Page 10: ...1 1 O Ov ve er rv vi ie ew w 2 2 System diagram ...
Page 48: ...2 Installation procedures 15 4 Handle unit option Corner pads Outer box Inner box ...
Page 133: ...Rev 01 CONTENTS Detector unit 1 X ray interface box unit 2 Wiring unit 4 Handle unit 6 ...
