Chapter 6: Ethernet Services and Interfaces
Configuring Ethernet Service(s)
phn-3963_008v000
Page 6-7
o
To disable the selected services, in the Multiple Selection Operation section underneath the Ethernet
Services Configuration Table, select
Reserved
and click
Apply
.
o
To delete the selected services, select
Delete
underneath the Ethernet Services Configuration Table.
Before deleting a service, you must delete any service points attached to the service, as described in
Figure 71
Multiple Selection Operation Section (Ethernet Services)
Note
When setting multiple services to
Reserve
state, make sure to avoid setting the management service
to
Reserve
state.
When setting multiple services to
Reserve
state, make sure to avoid setting the management service to
Reserve
state
Viewing Service Details
To view the full service parameters:
1.
Select
Ethernet > Services
. The Ethernet Services page opens (
).
2.
Select the service in the Ethernet Services Configuration table.
3.
In the Ethernet Services page, click
Service Details
. The Ethernet Services – Service Details page opens. The
Service Details page contains the same fields as the Add page (
). However, in the Service Details
page, these fields are read-only.
Configuring Service Points
This section includes:
•
Ethernet Services Points Overview
•
The Ethernet Service Points Page
•
•
•
•
Ethernet Services Points Overview
Service points are logical interfaces within a service. A service point is a logical entity attached to a physical or
logical interface. Service points define the movement of frames through the service. Each service point includes
both ingress and egress attributes.