Cambium Networks PTP 850E, User Manual, Page: 155 / 560

Chapter 6: Ethernet Services and Interfaces Configuring Ethernet Service(s)
phn-3963_008v000
Page 6-17
7. Click Apply , then Close .
Editing a Service Point
To edit a service point:
1.
Select
Ethernet > Services
. The Ethernet Services page opens ( Figure 93 ).
2. Select the relevant service in the Ethernet Services Configuration table.
3. Click Service Points . The Ethernet Service Points page opens ( Figure 96 ).
4. Select the relevant service point in the Ethernet Services Points – General SP Attributes table.
5. Click Edit . The Ethernet Service Points– Edit page opens. The Ethernet Service Points – Edit page is similar to
the Ethernet Service Points - Add page ( Figure 99 ). You can edit any parameter that can be configured in the
Add Service Point page, except
Service Point ID
,
Service Point Type
, and the
General SP Attributes
.
6. Edit the service point attributes, as described in Table 44 , Table 46 , and Table 47 .
7. Click
Apply
, then
Close
.
Deleting a Service Point
You can only delete a service point with an Attached Interface Type of Bundle-C or Bundle-S if no VLANs are
attached to the service point. See Attaching VLANs .
To delete a service point:
1.
Select Ethernet > Services . The Ethernet Services page opens ( Figure 93 ).
2. Select the relevant service in the Ethernet Services Configuration table.
3. Click Service Points . The Ethernet Service Points page opens ( Figure 96 ).
4. Select the relevant service point in the Ethernet Services Points – General SP Attributes table.
5. Click Delete . The service point is deleted.
Attaching VLANs
When the Attached Interface Type for a service point is set to Bundle-C or Bundle-S, you can add multiple C-VLANs
to the service point.
To add multiple C-VLANs:
1.
Select Ethernet > Services . The Ethernet Services page opens ( Figure 93 ).
2. Select the relevant service in the Ethernet Services Configuration table.
3. Click Service Points . The Ethernet Service Points page opens ( Figure 96 ).
4. Select the relevant service point in the Ethernet Services Points – General SP Attributes table.
5. Click Attached VLAN . The Attached VLAN List page opens.
Figure 76
Attached VLAN List Page