Chapter 6: Ethernet Services and Interfaces
Configuring Ethernet Service(s)
phn-3963_008v000
Page 6-15
Parameter
Definition
Marking admin
Determines whether re-marking of the outer VLAN (C-VLAN or S-VLAN) of tagged
frames that pass through the service point is enabled.
If
Marking admin
is set to
Enable
, and CoS preservation for the relevant outer
VLAN is set to
Disable
, the SAP re-marks the C-VLAN or S-VLAN 802.1p UP bits of
egress frames according to the calculated CoS and Color, and the user-configurable
802.1Q and 802.1AD marking tables. You can configure these tables by selecting
Ethernet > QoS > Marking
from the menu on the left side of the Web EMS.
If
Marking admin
and CoS preservation for the relevant outer VLAN are both set to
Enable
, re-marking is not performed.
If
Marking admin
and CoS preservation for the relevant outer VLAN are both set to
Disable
, re-marking is applied, but only according to the values defined for Green
frames in the 802.1Q and 802.1AD marking tables.
Service Bundle ID
This can be used to assign one of the available service bundles from the H-QoS
hierarchy queues to the service point. This enables you to personalize the QoS
egress path. Permitted values are 1-63.
Adding a Service Point
To add a service point:
1.
Select
Ethernet > Services
. The Ethernet Services page opens (
2.
Select the relevant service in the Ethernet Services Configuration table.
3.
Click
Service Points
. The Ethernet Service Points page opens (
4.
Select the relevant service point in the Ethernet Services Points – General SP Attributes table.
5.
Click
Add
. The Ethernet Service Points – Add page opens.