Cambium Networks PTP 850E, User Manual

Page: 142 / 560

Chapter 6: Ethernet Services and Interfaces Configuring Ethernet Service(s)
phn-3963_008v000
Page 6-4
Table 29 Ethernet Services Page Parameters
Parameter Definition
Services ID A unique ID for the service.
Service Type The service type:
•
MP – Multipoint
• P2P – Point-to-Point
•
MNG
– Management
Note : In release 10.6, only P2P and MNG services are supported. In
release 10.9, MP services are also supported.
Service sub type Indicates the type of service ( Ethernet ).
EVC ID
The Ethernet Virtual Connection (EVC) ID. This parameter does not affect
the network element’s behavior, but is used by the NMS for topology
management.
EVC description The Ethernet Virtual Connection (EVC) description. This parameter does
not affect the network element’s behavior, but is used by the NMS for
topology management.
Admin Indicates whether the service is enabled ( Operational ) or disabled
( Reserved ). You can configure services for later use by defining the
service as Reserved . In Reserved mode, the service occupies system
resources but is unable to transmit and receive data.
Adding an Ethernet Service
To add an Ethernet service:
1.
Select
Ethernet
>
Services
. The Ethernet Services page opens ( Figure 93 ).
2. In the Ethernet Services page, click Add . The Ethernet Services – Add page opens.