Chapter 19: Alarm Management and Troubleshooting (CLI)
Performing Diagnostics (CLI)
phn-3963_008v000
Page 19-26
To display the same information without the last RX error CCM and fault messages, enter the following command
in root view:
root> ethernet soam mep status general show meg-id <meg-id> mep-id <mep-
id> detailed no
The
Last RX error CCM message
field displays the frame of the last CCM that contains an error received by the
MEP.
The
Last RX Xcon fault message
field displays the frame of the last CCM that contains a cross-connect error
received by the MEP.
Note
A cross-connect error occurs when a CCM is received from a remote MEP that has not been defined
locally.
Performing Loopback (CLI)
To set the interval between loopback message transmissions in a loopback session, enter the following command
in root view:
root> ethernet soam loopback interval set meg-id <meg-id> mep-id <mep-id>
interval <0-60000>
For example, the following command sets the loopback interval for MEP 25 on MEG 1 to 5 seconds:
root> ethernet soam loopback interval set meg-id 1 mep-id 25 interval
5000
To set the loopback message frame size and data pattern, enter the following command in root view:
root> ethernet soam loopback data set meg-id <meg-id> mep-id <mep-id>
size <size> pattern <pattern>