Cambium Networks PTP 850E, User Manual

Page: 269 / 560

Chapter 10: Alarm Management and Troubleshooting Performing Diagnostics
phn-3963_008v000
Page 10-23
Parameter Definition
MHF (MIP) Creation
Determines whether MIPs are created on the MEG. Options are:
• MHF none – No MIPs are created.
• MHF default – MIPs are created automatically on any service point in the
MEG’s Ethernet service.
•
MHF explicit – MIPs are created on the service points of the MEG when a
lower-level MEP exists on the service point. This option is usually used when
the operator’s domain is encompassed by another domain.
MHF defer – No MIPs are created. Not used in the current release.
Table 47 SOAM MA/MEG Status Parameters
Parameter Definition
MA/MEG Name Format Reserved for future use. In the current release, this is Char String only.
Tx Sender ID TLV content Reserved for future use. Sender ID TLV is not transmitted.
Port Status TLV TX Reserved for future use. No Port Status TLV is transmitted in the CCM
frame.
Interface Status TLV TX Reserved for future use. No Interface Status TLV is transmitted in the
CCM frame.
MEP List Lists all local and remote MEPs that have been defined for the MEG.
Configuring MEPs
Each MEP is attached to a service point in an Ethernet service. The service and service point must be configured
before you configure the MEP. See
Configuring Ethernet Service(s) .
Each MEP inherits the same VLAN, C-VLAN, or S-VLAN configuration as the service point on which it resides. See
Configuring Service Points (CLI) .Configuring Service Points
In order to set the VLAN used by CCM/LBM/LTM if the service point is defined ambiguously (for example PIPE,
Bundle-C, Bundle-S, or All-to-One), the service point’s C-VLAN/S-VLAN parameter should not be set to N.A.
To configure a MEP, you must:
1.
Add MEPs to the relevant MA/MEG. In this stage, you add both local and remote MEPs. The only thing you
define at this point is the MEP ID. See
1. Adding Local and Remote MEPs .
2. Configure the local MEPs. At this point, you determine which MEPs are local MEPs. The system automatically
defines the other MEPs you configured in the previous step as remote MEPs. See
2. Configuring the Local
MEPs .
3. Enable the Local MEPs. See 3. Enabling Local MEPs .
Adding Local and Remote MEPs
To add a MEP to the MA/MEG:
1.
In the SOAM MA/MEG page, select a MA/MEG and click MEP List . The MEP List page opens.
Figure 171
MEP List Page